Difference between revisions of "Linker Mezzanine card starter kit for 96board"

From LinkSprite Playgound
Jump to: navigation, search
(Schematic)
Line 2: Line 2:
  
  
== Introduction ==
+
==Description ==
  
 
[[File:Arrow3874.JPG | 600px]]
 
[[File:Arrow3874.JPG | 600px]]
Line 15: Line 15:
 
== Package list ==
 
== Package list ==
  
== Demo ==
+
==Tutorials ==
  
[http://learn.linksprite.com/96-board/touch-sensor-and-led/ Touch sensor and LED]
+
*[http://learn.linksprite.com/96-board/touch-sensor-and-led/ Touch sensor and LED]
[http://learn.linksprite.com/96-board/blink/ Blink]
+
*[http://learn.linksprite.com/96-board/blink/ Blink]
[http://learn.linksprite.com/96-board/photoresistor/ Photoresistor]
+
*[http://learn.linksprite.com/96-board/photoresistor/ Photoresistor]
[http://learn.linksprite.com/96-board/sliding-rheostat/ Sliding rheostat]
+
*[http://learn.linksprite.com/96-board/sliding-rheostat/ Sliding rheostat]
[http://learn.linksprite.com/96-board/relay/ Relay]
+
*[http://learn.linksprite.com/96-board/relay/ Relay]
[http://learn.linksprite.com/96-board/tilt-module/ Tilt Module]
+
*[http://learn.linksprite.com/96-board/tilt-module/ Tilt Module]
[http://learn.linksprite.com/project/uart-communication/ UART communication]
+
*[http://learn.linksprite.com/project/uart-communication/ UART communication]
[http://learn.linksprite.com/project/read-temperature-using-tpm36-sensor/ Read temperature using TPM36 sensor]
+
*[http://learn.linksprite.com/project/read-temperature-using-tpm36-sensor/ Read temperature using TPM36 sensor]

Revision as of 03:52, 24 December 2015


Description

Arrow3874.JPG

Linker Mezzanine card starter kit is a shield breadout board designed for 96board. All the Linker kit modules can be plugged onto 96board through this card. There are bidirectional voltage-level translators which allows for low-voltage bidirectional translation between any of the 1.2-V,1.5-V, 1.8-V, 2.5-V, 3.3-V, and 5-V voltage nodes. So it compatibles with 3.3V or 5V module and make connecting peripheral more easily. You just plug a jumper onto JP9 to select which input voltage do you have. Moreover, this shield has an on-board ADC chip so that analog output modules can be used on 96board. The ADC chip used is MCP3004. It talks to 96board using SPI interface.

Features

There are 8 4-pin 2.54mm spacing housing on the card and these connectors covering Analog, UART I2C, and GPIO can connect Linker kit modules directly.

Package list

Tutorials