CuHead Pro WiFi/Ethernet Shield with AirPlay/DLNA Audio for Arduino

From LinkSprite Playgound
Revision as of 10:34, 30 July 2013 by Jingfeng (talk | contribs) (Audio Push)
Jump to: navigation, search

Description

What is CuHead Pro WiFi/Ethernet Shield with AirPlay/DLNA Audino for Arduino? It is a WiFi Shield, it is an Ethernet Shield, it accepts audio pushed from iphone, iPad, Andrid phone or pad Wirelessly.


Cuhead pro 0.jpg

Cuhead pro 1.jpg

Cuhead pro 2.jpg


Interface

Lets explain the interfaces:

  • USB host is reserved. It is for firmware updated in the future so that USB webcam can be used.
  • Ethernet RJ45 port. It is used for Ethernet communication where there is no WiFi signal, or where the WiFi Signal is bad.
  • Audio jack. It accepts any three segments audio jack.
  • J7 is the header used to choose which pins of Arduino are used to communicate with CuHead Pro. CuHead Pro can communicate with Arduino transparently through the UART interface. Please don't use D0 and D1. This is because that the hardware UART on Arduino TX/RD are pulled low during power up, and unfortunately CuHead pro will check its UART too during power up. If its pulled low, it will not start. So we can only use software serial port of Arduino to communicate with CuHead Pro.

Audio Push

First, lets look at interesting application. We are going to push music from iPhone to CuHead pro.

Lets make sure that J7 is configured so that pins 6 and pins 7 are installed as following:


Cuhead pro iphone 1.jpg

Install CuHead Pro on Arduino, and Arduino is connected to PC through USB connection. Yes. PC's USB can supply current for CuHead Pro.

When powered up, we can see four green LEDs of WiFi module turned on.

Cuhead pro iphone 2.JPG

After several seconds, there are only two LEDs still on, and they are steady on.

Cuhead pro iphone 3.JPG

Wait for another minute or two, the two LEDs will start to blink. This indicates that WiFi module is ready for use. We use iPhone to scan for WiFi network, and can see that there is a new AP, which is made by CuHead Pro. CuHead Pro works in AP client mode. It is a AP itself, so that it can provide AP service for other WiFi client. It can also connect to a router in home for Internet connection. From this point of view, it works more like a WiFI repeater.

We connect to the AP made by Cuhead Pro:

Cuhead pro iphone 4.JPG

Open the music application, we can see that there is an AirPlay icon in the lower right. Click the little triangle:


Cuhead pro iphone 5.JPG

Click AirPlay, we can select the device that will be used to play the audio: