GPS Shield With SD Card Slot for Arduino V2.0 B

From LinkSprite Playgound
Revision as of 09:38, 13 June 2013 by Jingfeng (talk | contribs) (Hardware Installation)
Jump to: navigation, search

Introduction

Arduino GPS shield is a GPS module breadout board designed for Global Positioning System receiver with SD interface. It is easy to use for recording the position data into SD card.


GPS-V2B-01.jpg

Features

  • With SD interface
  • Active antenna design with high receive sensitivity, compatible normal antenna
  • Extremely fast time to first fix at low signal level
  • UART interface
  • Operation temperature: -40℃ ~ +85℃


Application Ideas

Cautions

Schematic

Specification

Pin definition and Rating

Mechanic Dimensions

Usage

Hardware Installation

Install GPS SD Shield V2-B onto Arduino Uno, and use jumpers to short TX and MRX, RX and MTX.

HW-GPS-V2B-01.jpg

Programming

FAQ

Support

If you have questions or other better design ideas, you can go to our forum to discuss or creat a ticket for your issue at linksprite support.

Resources

How to buy

See Also

Other related products and resources.

Licensing

This documentation is licensed under the Creative Commons Attribution-ShareAlike License 3.0 Source code and libraries are licensed under GPL/LGPL, see source code files for details.