Difference between revisions of "Joystick Sensor Module"

From LinkSprite Playgound
Jump to: navigation, search
(Features)
(Introduction)
Line 2: Line 2:
 
This is a joystick module with Linker kit standard connection.  
 
This is a joystick module with Linker kit standard connection.  
  
[[File:Thumb joystick.jpg]]
+
[[File:N15DH WITHOUT PACKAGED FRONT.jpg|640px]]
  
 +
[[File:N15DH WITHOUT PACKAGED BACK.jpg|640px]]
 +
 +
[[File:N15DH WITHOUT PACKAGED SIDE1.jpg|640px]]
 +
 +
[[File:N15DH WITHOUT PACKAGED SIDE2.jpg|640px]]
 +
 +
[[File:N15DH PACKAGED FRONT.jpg|640px]]
 +
 +
[[File:N15DH PACKAGED BACK.jpg|640px]]
  
 
== Features ==
 
== Features ==

Revision as of 05:53, 6 September 2015

Introduction

This is a joystick module with Linker kit standard connection.

N15DH WITHOUT PACKAGED FRONT.jpg

N15DH WITHOUT PACKAGED BACK.jpg

N15DH WITHOUT PACKAGED SIDE1.jpg

N15DH WITHOUT PACKAGED SIDE2.jpg

N15DH PACKAGED FRONT.jpg

N15DH PACKAGED BACK.jpg

Features

Dimensions: 44.1×24.2×36.7mm

Net weight: 11g

Dimension

Tumb joystick dimension.jpg

Schematics

Application Ideas

test <syntaxhighlight lang="c"> /*

 Joystick AnalogReadSerial
Reads an analog input of Joystick on pin 0 and pin 1, prints the result to the serial monitor 
*/

void setup() {

 Serial.begin(9600);

}

void loop() {

 int sensorValue = analogRead(A0);
 int sensorValue2 = analogRead(A1);
 Serial.print("The X and Y coordinate is:");
 Serial.print(sensorValue, DEC);
 Serial.print(",");
 Serial.println(sensorValue2, DEC);
 Serial.println(" ");
 delay(200);

} </syntaxhighlight>

Joystick link.jpg

Resources

How to buy

Here to buy Joystick Sensor Module on store