Difference between revisions of "NXT/EV3 Brick Shield for Arduino"
Qian.zhang (talk | contribs) (Created page with "== Introduction == Use the NXT/EV3 Brick Shield to connect up to two LEGO NXT motors and four LEGO NXT sensors to an Arduino. *Supports up to two LEGO NXT motors, and readin...") |
Qian.zhang (talk | contribs) (→Introduction) |
||
Line 13: | Line 13: | ||
− | [[File:NXT_EV3 Brick Shield_1.jpg]] | + | [[File:NXT_EV3 Brick Shield_1.jpg | 600px]] |
== Resources == | == Resources == |
Revision as of 08:46, 22 May 2015
Introduction
Use the NXT/EV3 Brick Shield to connect up to two LEGO NXT motors and four LEGO NXT sensors to an Arduino.
- Supports up to two LEGO NXT motors, and reading their encoders
- Supports up to four simultaneous LEGO NXT sensors
- Supports LEGO NXT touch sensors on all four sensor ports
- Supports LEGO NXT 2.0 color sensor on two ports
- Supports LEGO NXT ultrasonic sensor on two ports
- Uses NXT cables
- Two TIP120 transistors help you switch larger loads
- Tested compatible with Uno, but will work on many other Arduino compatibles
Resources
How to buy
Here to buy NXT/EV3 Brick Shield for Arduino on store.