Tilt Module

Introduction

The Linker Tilt Module is the equivalent of a button, and is used as a digital input. Inside the tilt switch is a pair of balls that make contact with the pins when the case is upright. Tilt the case over and the balls don't touch, thus not making a connection. It is wired to the SIG line, NC is not used on this kit.

Sample

<syntaxhighlight lang="c">

int ledPin = 13; int switchPin = 7; int val = 0; void setup() {

 pinMode(ledPin,OUTPUT);
 pinMode(switchPin,INPUT);

} void loop() {

 //digitlRead(switchPin,HIGH)
 val = digitalRead(switchPin);
 if (HIGH == val)  digitalWrite(ledPin,HIGH);
 else  digitalWrite(ledPin,LOW);

}

</syntaxhighlight>

Schematics

• Schematics

How to buy

Here to buy Tilt Module on store